Wireless Flash: How can I make a Yongnuo YN-685 wirelessly shoot at MULTI with the YN622N-TX?

The only way I've been able to make the & # 39; Multi (Stroboscopic) Flash & # 39; function wirelessly through the YN622C-TX is to configure the multiple settings through the flash menu of my camera's camera with the YN622C-TX set to & # 39; Manual & # 39; for the group (s) that I'm using in the & # 39; Multi & # 39;

  • The flash must be set to & # 39; 622 Remote – Slave & # 39; The initial settings in the flash should be "neutral" values: power to 1/1, FEC to & # 39; 0 & # 39; and zoom to & # 39; Auto & # 39;
  • The YN622C-TX must be configured in & # 39; M & # 39; (manual).
  • If you want to set the power level of each flash to a different level, use the control panel of each flash to assign each flash to a different group.
  • You can set the power level through the YN622C-TX or the internal menu of the camera.
  • Use the camera's flash menu. [External Speedlite control] → [Flash function settings] to display the flash function settings screen.
  • Place the cursor on the upper left corner, press the & # 39; Set & # 39; button, change the mode to & # 39; Multiple & # 39; and press & # 39; Set & # 39; again.
  • Once selected & # 39; Multi & # 39 ;, use the & # 39; Quick control wheel & # 39; or & # 39; Joystick & # 39; to navigate directly under & # 39; Multi & # 39;
  • Place your cursor over the number of & # 39; Flash count & # 39; on the far left and press & # 39; Set & # 39; Use the & # 39; Quick Control Wheel & # 39; or the & # 39; Joystick & # 39; up or down to select how many flash pulses you want to shoot. Setting the value to [–] will cause the flash to fire at the set frequency while the shutter is open. Once the value is in the desired configuration, press & # 39; Set & # 39 ;.
  • Navigate to the immediate right, place the cursor over & # 39; Flash frequency & # 39 ;, press & # 39; Configure & # 39; and use the & # 39; Quick Control Wheel & # 39; or the & # 39; Joystick & # 39; up or down to select the number of pulses per second. (When you select & # 39; 1 & # 39; one pulse will be triggered per second .When selecting & # 39; 2 & # 39; it will trigger two per second / one every half second.When selecting & # 39; 3 & # 39; will trigger three per second / one every third of a second, and so on.) The lowest value that can be set is & # 39; 1 & # 39 ;, so pulses greater than one second apart are not possible . The highest setting is & # 39; 500 & # 39;
  • Make sure that your set shutter speed / time is long enough to allow the number of pulses you have selected to trigger at the intervals you have selected.

As long as you do not change the power level setting through the YN622C-TX, the flash will pulse according to the configuration each time you take a picture. If the power level is changed (or any other setting), everything will return from "multiple" to "Manual" (with one pulse per image). Then you will have to return to the camera menu to change back to "Multiple". & # 39;